FAQs

XPEL ULTIMATE Paint Protection Film uses a special polymer in its clear coat that flows even though it is cured. This allows the clear coat to find its natural level again after being disturbed on the surface.

The clear coat is designed to heal surface scratches and common swirl marks that occur during routine washing of the car. If the scratch penetrates through the film’s clear coat, it will not heal.

The time for a scratch to heal depends on the severity of the scratch and the ambient temperature. Minor scratches usually heal in one hour at room temperature (72°F). In warmer climates, healing time will be shorter. The healing process can be accelerated at any time by pouring hot water over the scratched area.

With this technology, there is no limit to the number of times the clear coat can heal itself. As long as the clear coat is not penetrated it will heal over and over again.

Depending on how the film is cared for, the clear coat can last indefinitely. Regular washing and waxing will keep the clear coat in top condition for years to come.

The clear coat on XPEL ULTIMATE has a very low surface energy, which makes it extremely difficult for organic compounds to stick to the film. Insects, bird droppings and environmental contaminants (which would normally cause yellowing) such as road oils, exhaust smoke and pollution can be removed during regular washing. An example of a similar technology would be Teflon, where a Teflon pan is easy to clean because nothing will stick to it.

If ordinary car wash or soap and water will not remove a stain, there are a variety of products available to do the job. In most cases simple isopropyl rubbing alcohol will remove anything on the surface of the film. In cases of more severe staining, or where something has been left on the film for a long period of time, a sparing amount of lacquer thinner can be used. Bug and tar remover available at any auto parts store is also effective. If you are unsure about the use of any other chemical on the surface of the film, please contact XPEL Support at 800-447-9928 for assistance.

XPEL ULTIMATE Paint Protection Film requires less maintenance than any other brand of film on the market. Our general care instructions are:

• Wait 48 hours after installation to wash your car
• Remove insect or other stains with bug and tar remover
• Stubborn stains can be removed with 99% isopropyl alcohol or lacquer thinner. Take care to keep these chemicals off the vehicle’s paint
• Seal with XPEL Flawless Finish Paint Protection Film Sealant at least once every 3 months to preserve high gloss
• Light scratches in the film will self-heal in 20-30 minutes at room temperature. In colder conditions, or to accelerate the process, pour warm water (120°F) over the affected area

Unlike most paint protection films on the market, XPEL ULTIMATE Paint Protection film can be waxed and sealed just like your paint. Though XPEL Flawless Finish Paint Protection Film Sealant is still the preferred product, any automotive wax or sealant may be used.

No. XPEL ULTIMATE Paint Protection Film allows UV to pass through the film and fade the paint underneath at the same rate as the exposed paint.

XPEL warrants XPEL ULTIMATE Paint Protection Film to be free from defects in materials and workmanship for ten (10) years from the date of purchase. Covered defects include: yellowing, staining, cracking, blistering and delaminating. This warranty does not extend coverage to damage caused by normal wear and tear, road debris impact, accidents, collisions or intentional damage of any kind.

Yes. Reimbursement for labor charges covered by the warranty will be made directly to the Authorized XPEL Dealer performing warranty replacement.